Lunsford titanium turnbuckle, hinge pin kit includes,

6 Titanium Turnbuckles
2 - 4mm x 101mm Titanium Turnbuckles (Steering)
4 - 5mm x 85mm Titanium Turnbuckles (Front & Rear Camber)
8 Titanium Hinge Pins
2 - 3mm x 43mm Outer Front
2 - 3mm x 44mm Outer Rear
2 - 4mm x 68mm Inner Rear
2 - 4mm x 71mm Inner Front
Note: Length measurement for these pins is from end to end

1 - 1/8th Scale Gas Wrench

Lunsford optional titanium hinge pin kit for use on the Hot Bodies D8 Nitro Buggy Kit.

HPI Racing shafts are made from Japanese steel, this shaft is tougher than stock.

Pro-Line straight from the design studios at Pro-Line into the hands of Ryan Cavalieri, Richard Saxton, Billy Easton and Chris Jarosz at the 2009 Nitrocross World Championships, the BullDog body was an immediate success. “My truck just works better-more steering, more predictable and faster lap times. The narrow design allowed me to see what my truck was doing which made tuning even easier at Nitrocross,” says Ryan Cavalieri. We couldn’t agree more. In fact, the body worked so well that Ryan went on to put the fastest lap time down in the final, the fastest average lap thus giving him the 2009 Nitrocross World Championship title in truck.

RCScrewZ Stainless Screw Kits are 100% complete. Your new kit will include everything needed to do a full conversion and more.

Hot Bodies replacement 50 tooth steel center gear for the Lightning Truck. This gear attaches to the center differential.

HPI Racing drive shaft is made from Japanese steel, these shafts are tougher than stock.

Hot Bodies replacement spiral differential bevel gear (large diff bevel) for the Lightning Series. This gear is attached to the differential case and mounts in the front or rear gearbox.

Hot Bodies radio tray set for use on the 1/8 scale D8 Kit.