Airtronics Receiver - M11X/MX-3X 4Ch 2.4GHz FHSS-3 AIR92744
AIR92744 Airtronics Receiver - M11X/MX-3X 4Ch 2.4GHz FHSS-3

Airtronics Receiver - M11X/MX-3X 4Ch 2.4GHz FHSS-3 AIR92744

reg $143.99
$99.95

In Stock.

This item qualifies for BUNDLE & SAVE
This item qualifies for FREE SHIPPING
The Airtronics 92744 4-Channel 2.4GHz FHSS-3 Surface Receiver is a conveniently sized, lightweight receiver that is compatible with all Airtronics 2.4GHz FHSS-3 capable surface transmitters.

Features:
  • One-Touch Binding
  • Single Receiver Antenna
  • Compatible with all Airtronics 2.4GHz FHSS-3 Capable Surface Transmitters
  • High Frame Rate, Low Latency FHSS-3 Technology
  • Nominal Input Voltage Up to 7.4v Allows Use of 7.4 Volt Servos
  • Convenient, lightweight setup
  • Engineered for the serious sport and competition
  • Great in cars, trucks and boats
The Airtronics 92744 Receiver was engineered for the serious sport and competition that demands the fastest response times and utmost reliability from using an Airtronics FHSS-3 system. The Airtronics 92744 Receiver works equally well in cars, trucks and boats.

In standard Airtronics fashion, the 92744 Receiver features a push-button binding procedure, single antenna for lighter weight and easier installation, and it's all packed in a convenient, lightweight setup.

Note: This receiver is compatible with all other Airtronics 2.4GHz FHSS-3 capable surface transmitters, such as the M11X, MX-3X and MT-4.
Frequency/Modulation Type: 2.4GHz/FHSS-3
Nominal Input Voltage: 4.8v ~ 7.4v
Weight: .019 lbs (0.30oz)
Dimensions: 1.43 x 0.94 x 0.59in (36.5 x 24.0 x 15.0mm)
Fail Safe: Yes (Programmable on All Channels)
Receiver Battery Fail Safe: Yes (3.8v Default / 3.5v ~ 5.0v Adjustable)
Connector Type: Universal 'Z'

Note:
This receiver has a Nominal Input Voltage rating of 4.8v ~ 7.4v, therefore, it can be powered using a 4 Cell to 6 Cell Ni-Cd or Ni-MH battery pack, or a 2S Li-Po or 2S A123/Li-Fe battery pack.

When using a 2S Li-Po battery pack you should NOT use servos rated for 4.8 or 6.0 volts, otherwise damage to your servos could occur. In this case, use high voltage 7.4 volt servos.

Review Summary