FEATURES: Associated (Intelligent Performance Control). New 7.1 software - longer run times, more power, superior initial acceleration, more constant braking, can be used with 4 cells without a receiver battery, programable automatic brake. Active current limiter is programmable with plug-in chips, has 4 different power programs. Fully proportional BRAKE with brake amplifier. Easy LED-controlled setup with only one button (no keypad or additional devices necessary for setup). Programmable digital start system minimizes reaction time, sets off the current limiter and optimizes acceleration time (the ultimate advantage at the start of a race).
Optional radio system connectors (Futaba J, Older Airtronics, KO, JR)
NO motor limitations

INCLUDES: One Pre-Wired Speed Control Unit with Universal Connector, Motor/Battery Wires, ON/OFF Switch and Servo Boost Wire One Schottky diode Three .01uf Capacitors One Set (Futaba J, JR & Older Airtronics) Radio Connectors.
One each: Plug-in Current Limiter Chips: 30, 50, 65, 80, & 120A)
One Double-Sided Tape
One Small Heatsink
One Large Heatsink
Four Nylon Straps
One Screwdriver
One Set of Decal
One Set of Instructions

REQUIRES: CONNECTORS for motor and battery

SPECS: Voltage Input: 4-8 cells (4.8-9.6V)
Internal Resistance: .00052 ohms
Momentary Load (1 sec): 690A
Brief Load (30 sec): 165A
Continuous Load (5 min): 100A
Pulse Frequency: 3140Hz
Note: All Current Ratings with transistor's rating at 25? Celsius Junction Temperature.
Weight with wires: 42 grams (1.5 ounces)
Length: 43mm (1.69")
Width: 34mm (1.34")
Height: 19mm (0.75")

COMMENTS: The single blue wire lead is used for FET servo that needs a
separate power source. Includes a ON/OFF switch
This is a 3-wire speed control *red- motor & battery positive
*blue- motor negative
*black- battery negative

A few differences between this and the old one are as follows:
NEW OLD
7.1 Software 6.0 Software
Momentary Load: 690A 610A
Brief Load: 165A 145A
Continuous Load: 100A 90A