HPI Nitro Star G3.0 Engine Pull Start HPI15105
HPI15105 HPI Nitro Star G3.0 Engine with Pull Start

HPI Nitro Star G3.0 Engine Pull Start HPI15105

reg $144.00
$94.95

In Stock. Usually ships within 24 hours.

This item qualifies for FREE SHIPPING

HPI Racing Nitro Star engine has composite body rotary valve carburetor with 5.5mm bore with silver colored cooling head. SG (pilot) type crankshaft. Two year limited warranty.

High Speed Needle Setting: Turn clockwise in 1/8 turn increments to lean fuel mixture. Do not exceed 2-1/2 turns from flush
Idle Adjustment: Adjust for about 0.04" (1mm) gap between slide valve and carb body at bore opening
Low Speed Needle: No adjustment recommended
Displacement: .18 cu in (3.0cc)
Distance Between Mounting Holes Same Side: 0.43" (11mm)
Distance Between Mounting Holes Opposite Side: 1.22" (31mm)
Height/Bottom Mounting Flanges to Top of Cylinder Head: 2.99" (76mm)
Height/Bottom of Crankcase to Top of Cylinder Head: 3.5" (89mm)
Length from Pull Starter to End of Crankshaft: 4.13" (105mm)
Length from Pull Starter to Front Bearing: 3.3" (75.3mm)
Length from Center of Crankcase to End of Crankshaft: 2.96" (75mm)
Diameter of Carburetor Bore: 0.21" (5.5mm)


Requires:

Fuel: Car blend with 20-25% nitro content
Misc Items: Fuel tubing and track equipment

High Speed Needle Setting: Turn clockwise in 1/8 turn increments to lean fuel mixture. Do not exceed 2-1/2 turns from flush
Idle Adjustment: Adjust for about 0.04" (1mm) gap between slide valve and carb body at bore opening
Low Speed Needle: No adjustment recommended
Displacement: .18 cu in (3.0cc)
Distance Between Mounting Holes Same Side: 0.43" (11mm)
Distance Between Mounting Holes Opposite Side: 1.22" (31mm)
Height/Bottom Mounting Flanges to Top of Cylinder Head: 2.99" (76mm)
Height/Bottom of Crankcase to Top of Cylinder Head: 3.5" (89mm)
Length from Pull Starter to End of Crankshaft: 4.13" (105mm)
Length from Pull Starter to Front Bearing: 3.3" (75.3mm)
Length from Center of Crankcase to End of Crankshaft: 2.96" (75mm)
Diameter of Carburetor Bore: 0.21" (5.5mm)
  • HPI Nitro RS4 MT2
  • HPI Firestorm 10T 2.4
  • HPI Nitro RS4 3

Review Summary