Warning: Last items in stock!
This is a Super Hot-Shot #2 Standard Glo-Starter with battery charger. This is used to heat glow plugs to start glow-powered engines.
Includes: One Super Hot Shot 2 Standard Glo-Starter with red rubber protective cap, one Hot Shot #2 Glo-Starter battery charger and one Instruction/Header Card
Sanyo NiCd Battery: 5000mAh 1.2V
AC Charger Input: 110-120V AC 60Hz (US Standard)
AC Charger Output: 1.25V DC 500mA
Hot Shot Overall Length: 4-5/8" (118mm)
Hot Shot Shaft Length: 2-1/4" (57mm)
Hot Shot Diameter: 1-5/16" (33mm)
Note: How to use- To lock onto your engine's glow plug, place the end of the Hot Shot 2 over the plug and push down. Twist the Super Hot Shot #2 clockwise to lock into place.
Charging- Before using, initial Charge should be 12 to 14 hours. Subsequent charging time is approximately 10 hours.
The charger originally packaged with this Glo-Starter has a 150mAh charge rate which requires a long time to charge the large mAh battery. The modeler charges the battery initially for 24 hours. After that, 12-hour charges each. If modeler is a regular flier then charge twice a month for 24 hours.
|Main Category||Field Equipment|
|Free Shipping||Free Shipping|
"Doesn't get any better"
Recommended to buy: Yes
Does this super hot shot 2 come with a charger as well?
Yes indeed it does,
One Super Hot Shot 2 Standard Glo-Starter w/Red rubber protective cap
One Hot Shot #2 Glo-Starter Battery Charger
One Instruction/Header Card
Customers also purchasedâŚ