| FEATURES: Chassis: Woven graphite 1/8" (3mm) thick, woven graphite upper and middle deck and shock towers Drive: Four wheel belt drive Ball bearings: full set Shocks: Four oil filled aluminum threaded bodies Gearbox: Open front and rear Differentials: Front one-way, rear carbide ball diff Sway bars: 1.4mm front and rear bars Bumper: Front foam Suspension: Adjustable Wheelbase: Adjustable from 10.1"-10.2" (256mm-259mm) Camber Tie Rods: Adjustable front and rear, camber refers to the angle of the tops of the tires from vertical when when viewed from front or behind vehicle Caster: Adjustable front and rear, caster/toe-in refers to the angle of the suspension when viewed from the side of the car in relation to the chassis Ackerman: Adjustable, Ackerman describes the effect of the inside front wheel turning tighter than the outside front wheel Roll Center, Ride Height and Down Stops: Adjustable front and rear Bump Steer, Anti-Dive/Kick-Up: Adjustable Steering: Ball bearing supported, single bellcrank Servo Saver: Spring loaded, incorporated into steering bellcrank INCLUDES: Hot Bodies Cyclone Touring Car with four oil-filled shocks, 100t 64 pitch spur gear, ball bearings, carbon fiber chassis, shock towers foam front bumper, aluminum pivot blocks, titanium turnbuckles REQUIRES: Radio: 2-Channel with 2 Servos Radio Batteries: (8) AA size Speed Control: Electronic of modeler's choice Motor: Modeler's choice Wheels:24mm width, but modeler's choice Tires: 24mm width, but modeler's choice Pinion: Modeler's choice Battery: 6 cell side by side configuration Charger: AC/DC timed or peak for battery Paint: For polycarbonate body Misc. Items: Building and track equipment SPECS: VEHICLE- Length: 14.4" (365mm) Width: 7.5" (190mm) Weight: 3.15lbs (1430g) with motor, battery and electronics Wheelbase: Adjustable from 10.1"-10.2" (256mm-259mm) Drive Ratio: 2.4375:1 COMMENTS: For Replacement Ball Bearings use: Qty. Size Location Bearing Set Qty. 4 10mm X 15mm Outdrives X 2 2 4mm X 8mm Differential X 1 8 5mm x 10mm Hub Carriers X 4 2 4mm x 7mm Bellcrank X 1 1 5mm x 8mm Differential X 1 |
