Mugen glow powered, radio controlled, 1/8 scale. Preassembled MBX6 M-Spec Buggy.

Mugen Chassis: A7075 T6 aluminum 0.12" (3mm) thick
Drive: Four wheel three differential shaft drive Shocks: Four oil filled aluminum body
Front; 450wt oil 10T super soft springs
Rear; 400wt oil 11T super soft springs
Shock Towers: 0.16" (4mm) thick carbon graphite Gearbox: Sealed, front and rear
Differentials: Three, planetary geared
Fuel Tank: 5.1oz (150cc) approximate
Transmission: Single-speed
Ball Bearings: Full set
Suspension: Pillow ball
Body: Clear buggy type
Clutch: 3-shoe aluminum
Clutch Bell: 13 tooth steel
Spur Gear: 46 tooth
Wheels: Pro-Line White 1.6" (41mm) wide, 3.1" (79mm) diameter
Tires: Pro-line #9030 Cailber dual stage pin design, 3.1" (79mm) diameter, 1.7" (43mm) wide with inserts Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis
Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle
Steering: Bell-crank type, with carbon graphite steering brace and adjustable Ackerman. Ackerman describes the effect of the inside front wheel turning faster than the outside front wheel during turns

Engine: .21 cu in rear exhaust
Exhaust: Tuned pipe with manifold
Radio: 2-channel with standard servo for throttle and high torque servo for steering
Starter Box: For 1/8 scale buggy use
Building and track equipment