| Tamiya Chassis: NDF-01 reinforced resin with die-cast aluminum engine mount Drive: Four wheel shaft drive Engine: .15 cu in (2.5cc) with pull-starter, rear exhaust, glow plug and Slide Valve Carburetor Exhaust: Tuned pipe Fuel Tank: 2.5oz (75cc), flip top cap Clutch: Two shoe Transmission: Single-speed Ball Bearings: Fully equipped Shocks: Four oil-filled with coil-over spring Main Gear: 57 tooth, plastic Gearboxes: Sealed, front and rear Differentials: Planetary geared Brakes: Single, disk Tires: Directional racing tread, 3.5" (90mm) outer diameter, 2.6" (67mm) inner diameter, 1.5" (39mm) wide Wheels: White 6 spoke (spokes are in groups of two) 2.4" (62mm) diameter, 1.5" (38mm) where tire fits into grooves Body: Clear buggy with rear wing Bumpers: Front, with Frontal Impact Control System (FICS), expandable suspension mount absorbs impact during a frontal collision Suspension: Front and rear double wishbone Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when when viewed from front or behind vehicle Steering: Direct Servo Saver: Included
INCLUDES: Tamiya Nitro Force Buggy with 4 oil-filled shocks, .15 cu in (2.5cc) engine, glow plug, air filter, clear body with wing, tires, wheels, 13 tooth clutch bell, 57 tooth spur gear, decal sheet, instructions |
