Traxxas silicone grease is used throughout most all of the Traxxas kits, it can also be used in most any R/C greasing application.

Traxxas hop-up replacement shock caps (Big Bore) are designed to fit Big Bore shocks.

Traxxas replacement piston head set for Big Bore Shocks.

Traxxas 5.8mm ball ends and balls used in the LS II race truck kit.

Traxxas rod ends short for the Nitro T-Maxx. These rods ends attach to turnbuckles for front/rear.

Traxxas Nylon Tie Wraps Nitro Hawk (6)
package contains the direct replacement nylon tie wraps that comes included with the Traxxas Nitro Hawk.

Traxxas replacement 4-cell battery holder for the Ready-to-Run gas kits (Nitro Hawk, Nitro Street, Nitro Buggy, etc). This receiver battery box holds four "AA" batteries and powers the receiver.

Traxxas rod guides w/nuts for the Nitro Hawk

Traxxas pair of screw collars (exactly the same as wheel collars) and 3mm set screws to secure the collars to the wire.

Traxxas stock replacement springs for the Nitro Hawk.

Traxxas replacement split bevel cone for the Nitro Vee Boat. This cone is part of the engine assembly.

Traxxas replacement Fuel Inlet Fittings. This will work for the Traxxas T-Maxx.

Traxxas package of 3x12x5mm shoulder screws for many Vehicles.