Novak Mod 1 5mm Steel Pinion 3-Pack NVK5123
NVK5123 Novak Mod 1 5mm Steel Pinion 3-Pack (18/19/20)

Novak Mod 1 5mm Steel Pinion 3-Pack NVK5123

Add $99.00 to receive Free for eligibility
reg $24.95

In Stock.

This item qualifies for FREE SHIPPING

Novak's 5mm Mod 1 Steel Pinion Gears: 18T-20T are, overall, shorter in length to easily fit into all popular brushless 1/8-scale vehicles. These shorter gears allow uses to take advantage of the lower Kv generated by the HV Sintered Tuning Rotor with 5mm Shaft - 14mm. Additionally, the vehicle's gearing must be decreased for an overall lower gear ratio.

This is the pack of 18, 19 and 20 Tooth Mod 1 Steel Pinion Gears from Novak.
**Will not work with 32P spur gears used on the Traxxas E-Maxx**
**or HPI E-Savage.**

Hardened steel construction
Recommended when converting 1/8-scale nitro off-road vehicles for brushless electric use
Fits Mod 1 spur gears commonly found on 1/8 scale nitro vehicles
Compatible with Novak's HV High-Voltage Brushless Motors and other brushless motors with a 5mm output shaft
Allows driver to experiment with different gear ratios
Number of teeth stamped on back of each gear

Installing on motor shaft and tightening set screw"
Inside (shaft) Diameter: 5mm
Pitch: Mod 1

Review Summary