| This Factory Team Jammin' X1 CR has the following upgrades from the original version; Pro Shocks w/ 13mm Bodies Fiberglass Disc Brake CNC Front B Block Special Arm Pin Set CNC Shock Towers 5mm Shock Towers Captured Hinge Pins FEATURES: Chassis: 0.12" (3mm) CNC countersunk aluminum with 0.20" (5mm) thick shock towers Drive: Four wheel, shaft driven Fuel Tank: 4.2oz (125cc) w/flip top cap Clutch: Aluminum 3-shoe clutch Transmission: Single Speed Ball Bearings: Full set Shocks: Four Pro threaded with 13mm diameter hard anodized aluminum bodies Main Gear: 48T steel Gearbox: Sealed both front and rear Differentials: Planetary geared front and rear Brake: Fiberglass disk Body: Clear buggy Tires: Jammin' Ripper square spike tires with foam inserts 2.6" (66mm) inner diameter, 1.6" (40mm) wide Wheels: 2.6" (66mm) diameter plastic dish wheels, neon yellow in color Bumpers: Front high strength nylon Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle Steering: Bell crank type w/servo saver INCLUDES: Jammin X1CR Factory Team rolling chassis with shocks, lexan body, tires, wheels, foam inserts, 48T steel spur gear, aluminum engine mount, medium fuel tubing, foam air filter, instruction manual molded neon yellow rear wing, stickers, window mask sheet REQUIRES: Radio: 2-Channel with 2 standard size Servos (high torque servo for steering recommended but not required) Radio Batteries: (8) AA size Engine: .21 w/rear exhaust and pilot shaft Tuned Pipe and Manifold for Rear Exhaust Glow Starter: 1.2 volt |
