| FEATURES: Chassis: Plastic tub TT-01 design Drive: Four wheel shaft drive Motor: 540 motor with pre-attached leads Plastic and metal bushings Shocks: Friction plastic body Gearbox: Open, front and rear Differentials: Bevel gear Transmission: Single speed Tires: 2.6" (65mm) outer diameter, racing radial type Wheels: Five spoke, 2" (51mm) outer diameter, silver Speed Control: Electronic, standard connectors Bumpers: Foam front bumper Suspension: Fixed non-adjustable Camber Tie Rods: Fixed non-adjustable, 3 part Steering Tie Rods: Fixed non-adjustable Steering: Bell-crank type Servo Saver: Included INCLUDES: Enzo Ferrari rolling chassis with friction type shocks, 540 motor, electronic speed control, clear body, tires, foam bumper, spoke wheels, 19 tooth pinion gear, 61 tooth spur gear, decal sheet and instructions. _ REQUIRES: Radio: 2-channel with 2 standard servos Radio Batteries: 8 AA size Battery: 6 flat pack with standard connector Charger: AC/DC timed or peak for 6-cell battery Paint: paint for a lexan body Misc. Items: building and track equipment SPECS: VEHICLE- Length: 17-1/4" (436mm) Width: 7.9" (202mm) Height: 4-5/8" (116mm) Weight: 2.2lbs (990g) kit only 3.3lbs (1490g) with battery, speed control, motor and radio equipment Wheelbase: 10.1" (257mm) Tread: Front- 6.3" (159mm) Rear- 6.2" (157mm) side-to-side at wheel centers Ground Clearance: 0.35" (9mm) Gear Ratio: 8.35:1 Tires- Width: 1" (26mm) Wheels- Width: 1" (26mm) Inner Diameter: 1.8" (46mm) Diameter: 1.9" (47.5mm) Outer Diameter: 2.6" (65mm) BODY- Length: 17-1/4" (436mm) Width: 7.9" (202mm) at rear wheels (widest point) Height: 4-1/2" (114mm) COMMENTS: For Replacement Ball Bearings use: Qty. Size Location Bearing Set Qty. 12 5 x11mm front & rear diff gears, hubs, 4 8 X12mm front & rear diff gears. Body pictured on the box is painted with the following Tamiya colors, Polycarbonate paint, PS-2 Red Plastic Paint TS-8 Red TAM R5008. |