Tekno brushless conversion,
* Factory Finish - hard anodized chassis, black anodized and injection molded components
* Lowest CG of any conversion, provides better handling and higher capacity batteries
* 4mm 7075-T6 CNC hard anodized chassis - only the best, no stamping here
* No extra holes, no drilling, no mods - designed for electric racing by electric racers
* Patent pending Elektri-Clutch system to tune the power delivery of the hottest brushless motors. Our hardened steel clutchbells will last and last because the motor is disengaged from the drivetrain off power. For those that prefer direct drive, our kits are compatible with long shank 5mm bore mod1 pinions as well. More options and flexibility than any other kit on the market.
* Patent pending 1-piece motor mount/heatsink fully supports your motor and provides superior cooling under the most rigorous conditions. Need more cooling? Slap a 40mm fan on the integrated fan mount
* Mechanical brakes with front/rear brake bias provides world class handling while lowering operating temps and easing the stress on your motor, ESC, and drivetrain
* Optimized left-to-right and front-to-rear weight balance - battery is as close to center as possible for the best handling of any electric 1/8th scale on the market
* Included radio tray keeps the wires neat and features an integrated transponder mount
* Low CG battery tray (165x52mm) is countersunk into the chassis -1.5mm and keeps the battery protected while allowing the most height clearance of any setup on the market
* Proven tough Tekno RC battery strap system WILL protect your batteries and will NOT break from hard landings
* Servo mounts feature integrated cable guides to keep your servo wires neat and away from hazardous moving parts
* Includes full Tekno RC 1/8th Elektri-Clutch setup - adapter, clutch shoes, .8mm clutch springs, 14t 1/8th clutch bell and bearings, an unbeatable value
* Custom chassis mud guards keep the dirt away and finish off the factory quality kit
* Tekno RC - No compromises!

Note: 3 Channel radio with channel mixing may be required for use with mechanical brakes depending on your setup. M11, DX3R, DX3.0, Futaba 3PK, 4PK, etc.

Kit includes:

* 1/8th Scale Electric specific 4mm CNC machined and hard anodized 7075-T6 chassis
* Patent pending motor mount (available for 36mm or 44mm motor diameters)
* Complete Tekno RC 1/8th Elektri-Clutch system - adapter, hard alum. shoes, .8mm springs, 14t clutch bell and bearings
* Low CG long battery tray w/ battery straps (165x52mm)
* Radio tray w/ integrated transponder mount
* Servo mounts w/ integrated wire guides
* Chassis mud guards
* Rear chassis brace
* All necessary hardware
* Detailed installation instructions