Warning: Last items in stock!
These are the optional front & rear steel driveshafts for the 1/16 scale Traxxas Summit VXL.
Includes: Front (short) Driveshaft, Rear (long) Driveshaft, Four Screw Pins, Two Drive Cups, Two CV Joints, Two O-Rings and Instruction Sheet
Note: These are driveshafts that connect to the either end of the center differential. There is no "center driveshaft" included.
|Main Category||R/C Parts|
|Car & Truck Parts||Driveline Components|
|Part Type||Stock Parts|
|Free Shipping||Free Shipping|
No customer reviews for the moment.
How to install the TRA7250R?
1. Using a 2mm allen wrench, unscrew
the 3x10BCS screws securing the
center skid. Remove the 2.5x12CCS
screw and the 2.5x8CS screws to
remove front skid plate(A). Unscrew
the toe links and the servo arm from
the bell crank to remove the bellcrank
assembly. Remove the rear skid plate
by removing the 2.5x8CS screws.
2. Using a 1.5mm allen wrench, unscrew
and remove the driveshaft screw pins
and remove the center driveshafts (B).
3. Install rear drive cup onto the rear
differential input shaft (C). Install front
drive cup onto front transmission
output shaft. Use supplied screw pins
with thread locker.
4. Insert the driveshafts into the
drive cups, and install the constant
velocity(CV) drive joints using
supplied threadlocked screw pins(D).
Important: Install shafts and cups using
5. Reinstall bellcrank assembly, rear skid
plate, center skid plate, and front skid
Customers also purchasedâŚ