Warning: Last items in stock!
|Main Category||Motors & Accessories|
|Part Type||Hop-up Parts|
|Free Shipping||Free Shipping|
Cells: Controller and motor max 2S
Reverse: Yes, can be set with reverse lockout for racing
Low Voltage Cutoff: Programmable
ESC Size: 1.8"L x 1.4"W x 0.9"H
Motor Size: 53mm length, 38mm diameter, Standard 5mm motor shaft.
ESC Weight with wires: 2.2 oz (62.4 g)
Connector Type: Motor connected to controller with 4mm bullets (installed)
No customer reviews for the moment.
how fast will my car go if I put this system in it
This all depends on what RC you are putting it in along with gear ratio's and what battery pack your using. This systems can be used in RC's that are under 6.5 lbs on a 2s lipo pack. Then on 2wd RC's under 4 lbs max cell of 3s lipo.
what is the difference between this and the velineon vxl-3s and wich would be better for the slash 2wd
This one has a bit higher RPM than the Velineon and will come with the motor fan and ESC fan but will not come with the battery plug that you would need so you would have to get the plug and solder it on. If you want a simple drop in then the Velineon would be the best but as for performance the SV3 would be a bit better.
Will this fit my Stampede?
Yes, this will fit in a Stampede.
Will this fit on a SCX10 and Wraith?
Yes this will fit in the SCX10 and Wraith, just make sure to get a 5mm bore pinion. Or get the CSE010-0123-00 that has the 3.2mm shaft.
What is the max and min voltage this engine can run on?
Input Voltage: Minimum 2S LiPo 7.4 volt, maximum 3S LiPo 11.1 volt.