Dynamite LiPo Battery 7.4V 5000mAh 2S 20C Case EC3 DYN9004EC
Dynamite LiPo Battery 7.4V 5000mAh 2S 20C Case with EC3 Connector.
Warning: Last items in stock!
More information about Dynamite LiPo Battery 7.4V 5000mAh 2S 20C Case EC3 DYN9004ECThis is the Dynamite LiPo Battery 7.4V 5000mAh 2S 20C Case with EC3 Connector.
- Pre-wired with an EC3™ connector and JST-XH balance connector
- Value-priced without sacrificing quality or performance
- Hard case design
- Designed to fit most 1/8- and 1/10-scale vehicles
Specifications for Dynamite LiPo Battery 7.4V 5000mAh 2S 20C Case EC3 DYN9004EC
|Batteries & Accessories|
International Shipping Restriction
|International Shipping Restriction|
Connector Type: EC3
Wire Gauge: 12AWG
Number of Cells: 2
Length: 5.45 in (138.5mm)
Width: 1.81 in (46mm)
Height: 0.98 in (25mm)
Maximum Continuous Discharge: 20C
Maximum Burst Discharge: 40C
Reviews for Dynamite LiPo Battery 7.4V 5000mAh 2S 20C Case EC3 DYN9004EC
No customer reviews for the moment.
Questions and answers about Dynamite LiPo Battery 7.4V 5000mAh 2S 20C Case EC3 DYN9004EC
Does the exc9011 just plug into the electrix 1/10 stadium 2wd truck.
From what we can recall and find the Electrix is an older line that had the old 27 MHz transmitters and receivers in them so this receiver EXC9011 would not work with them. You would have to upgrade the receiver and transmitter to the 2.4 GHz.
how long does the battery take to charge
That will depend on the charger that your using, if you can charge this at 5 amps and the pack has been drained to the cut off then it would take about an hour and 20 minutes or so to fully charger. If you charge it at a lower amp rate it will take longer.
Is the EC3™ connector the on that works with Traxxas? If not, can I make a special order when the time comes for me to buy a battery?
The EC3 connector is the blue connector and will not work with the Traxxas plugs, they do have this pack that comes with the Traxxas plug, the part number is DYN9004T.
Will this work with my Ruckus ECX 2wd 1/10?
Yes this will work perfectly in your 1/10th scale ECX Ruckus.