Warning: Last items in stock!
This is the ECX Ruckus 1/18 scale 4WD Monster Truck RTR. The ECX Ruckus, the largest basher in the ECX lineup, is here to take on 1/18 scale thrills.
The ECX Ruckus Monster Truck has impressed drivers ever since it hit the RC scene. Big or small, every edition of this havoc-inducing monster truck has stood up to the trials and tribulations of abusive backyard bashing. Whether you're looking to hit massive jumps, want to attack rugged terrain or just need a convenient rig that you can take just about anywhere, the ECX Ruckus is in for the long haul. The 1/18-Scale ECX Ruckus Monster Truck comes ready to dominate the pavement with beastly features and ferocity. A shaft-driven 4WD drivetrain and waterproof electronics keep the Ruckus driving where other bashers simply can't. This unrelenting monster truck also comes well-equipped to bruise your competition with hard-hitting durability that keeps it driving even when the going gets rough.
|Ready to Run|
|Skill Level 1|
International Shipping Restriction
|International Shipping Restriction|
Type: 4WD Monster Truck
Length: 10.51 in (267mm)
Width: 7.72 in (196mm)
Height: 4.25 in (108mm)
Ground Clearance: 1.22 in (31mm)
Wheelbase: 7.01 in (178mm)
Weight: 1.68 lbs (763g)
Chassis: Molded Nylon Composite
Tire Type: Monster Truck
Motor or Engine: 380 Brushed
Radio: 2Ch, 2.4GHZ
Batteries: 7.2V 900mAh Stick pack (flat)
Charger: NiMH AC charger
Gear Pitch: 0.5 Module
Wheel Size: 1.57 in (40mm Diameter) 1.26 in (32mm Width)
Shock Type: Coil over
Body: Monster Truck, painted or screened
Ball Bearings: Transmission only
Minimum Age Recommendation: 14 years
No customer reviews for the moment.
Will the 1200 mah battery fit this car? And will it work
Yes the 1200 Mah pack will fit and work in this RC, the part # DYN1473 is what comes with the truck.
What's the difference between these two fast charger's DYNC2000CA or the DYNC2010CA.?I'm looking to get this truck and bundle, ECX Ruckus 1/18 4WD Monster Truck RTR ECX01000T1
The DYNC2000CA will only charge NiMh packs and will charge between 1.0 to 4.0 amps. The DYNC2010CA will charge NiMh (1–8C) or Li-Po (1–6S) packs from 0.1 to 5.0 amps. The DYNC2010CA is a better charger especially if you are getting more into the hobby and plan on running lipo packs in the future. It also has the bullets so you can purchase many different adapters for different battery types and brands.
How long does the battery last on a full charge? How fast does it go?
This goes about 20-25 mph and a fully charged pack will last for about 11-13 minutes.
Is it water proof while thing
This has been pulled directly from the owners manual, "Your new Horizon Hobby vehicle has been designed and built with a combination of waterproof and water-resistant components to allow you to operate the product in many “wet conditions,” including puddles, creeks, wet grass, snow and even rain. While the entire vehicle is highly water-resistant, it is not completely waterproof and your vehicle should NOT be treated like a submarine. The various electronic components used in the vehicle, such as the Electronic Speed Control (ESC), servo(s) and receiver are waterproof, however, most of the mechanical components are water-resistant and should not be submerged."
how high of amperage battery can this handle without smoking the esc
The highest you can go with the stock ESC is 7.2 volts.
If I was to upgrade motors to a Dynamite 550 Brushed Motor 15-Turn DYNS1215 would I have to change any of the other components
The DYNS1215 will not fit in the 1/18th scale RC's.
Can I upgrade the speed in this truck. If yes can you help me whit the parts
You could upgrade this truck to make it faster but you would have to change pretty much all of the electronics in it since the ESC/ receiver are an all in one unit, you would have to change the ESC, receiver and transmitter... Here are the part numbers of the items we would recommend CSE010-0147-02 and SPM2330, then you could go with a LiPo and charger upgrade as well.
ive lost a wheel nut and i dont want to buy the screw that they see what should i get
These are just a 3mm lock nut, we would recommend the Dynamite Flanged Locknuts Blue Aluminum 3mm (10) part #DYN8552.