Warning: Last items in stock!
Traxxas racing engine with recoil and pull start
This is the Traxxas 2.5R Racing Engine with IPS
(Integrated Pilot Shaft) and Pull-Start.
For use in all Traxxas vehicles that use the TRX 2.5 engine.
** This engine is a .15 engine. The 2.5 refers to a measurement of Cubic centimeter displacement compared to Cubic Inch displacement (.15).
60% More Power that the TRX Pro .15 engine!
Loaded with advanced features such and the free flowing rear exhaust, the
unique composite slide carb, and innovative porting only found on the mostexotic racing engines.
Features: Slide carburetor provides less restrictive, straight through airflow
for more power and better throttle response.
PowerTune head is machined from aluminum which promotes even heat distrubution for stable engine tempatures and rock-solid tuning. New sleeve for improved engine efficiency and better power.
Molded head proctector prevents damage to the head and secures the glow plug wire.
Ultra-low restriction air filter provides superior air flow and
filtration for more power and a long engine life.
Offset wrist pin further reduces piston slide loading for more even cylinder wear, and longer engine life.
This package includes: One 2.5 (0.15cu in) Engine with Pull Starter w/flywheel nut
One 90 degree air filter (includes base for upright mounting)
One 22 chapter Engine Set-up DVD
One Owners manual/instruction booklet
One bottle of air filter oil
One Decal sheet
One pre-installed glow plug
The TRX 2.5R (REVO) engine has a different cylinder head, crankcase,and sleeve than the TRX 2.5. All of the upgrade parts from the TRX 2.5R will fit on the TRX2.5
|Engines & Accessories|
|.16 & UP - CAR|
"good engine but should come with flywheel and clutch parts fitted to the engine"
Recommended to buy: Yes
"EASY TO TUNE"
"way easier to tune and gave life back to my truck"
Recommended to buy: Yes
I have the t maxx with the pro.15 in it now. Will this engine mount right up to it without conversion? And the picture shows electric start but the writing says it's a pul start. Does it come just like picture shows electric start and carb. And how much more power does it have compared to the pro.15
Unfortunate this engine will not just bolt in although it is a pretty easy conversion. You would need TRA4900 this along with the engine and you should be set. The 2.5 and 3.3 have slide carbs and not the rotary carb so your linkage and mount has to change to accommodate the slide carb. You do also have to drill a hole into the chassis but its not that bad. This engine comes with a pull start and does not come with the electric start. If you did want to keep the electric start then you would need to upgrade to the EZ start 2 system. As for power, they don't really offer exact specs on these engines but the 2.5 and 3.3 are night and day difference from the .15.