Warning: Last items in stock!
Traxxas bellcrank set is constructed of black composite nylon. Replaces a worn or damaged bellcrank set. This will also work as an upgrade for the Nitro Maxx Series and the E-Maxx.
INCLUDES: One Left Bellcrank Lower
One Left Bellcrank Upper
One Right Bellcrank
One Spring Cap
One Servo Saver Spring
Two 3x12mm Shoulder Screws (2.5mm hex size)
Six 3x15 Button Head Cap Screws (2mm hex size)
One Black Nylon Spacer
Two White Nylon Spacer
Assembly and installation following the model manual (a installation sheet is included for T-Maxx and E-Maxx installations)
|Main Category||R/C Parts|
|Car & Truck Parts||Steering Components|
|Part Type||Stock Parts|
|Free Shipping||Free Shipping|
This will do until my aluminum bell-crank comes in!
It's a great part as long as you don't do any heavy bashing. My original part On my Brushless E-maxx held up great, even through some pretty bad crashes. The crash that snapped it happened at 50 mph and to be fair it did roll over about 15 times. To sum up, it's a great part that will hold up much better than most stock parts. I only ordered this because my integy bell-crank is back-ordered until March so this should hold up until then. This is definitely a great spare part to have!
Recommended to buy: Yes
Are these for the duel steering servos on the E-Maxx?
These are the stock replacements for the dual servo setup, it looks like you might need the part number TRA3968 as well.