This is the Castle Creations Mamba Micro X waterproof electronic speed control with the 0808-5300Kv brushless motor.
Requires: Compatible LiPo Battery, recommended battery capacity for 1/18 scale vehicles is 1500mAh, 30C or higher continuous discharge, Pinion and spur gear depending on application
Note: Not intended for operation while submerged in liquid. If unit is operated in wet conditions, rinse with fresh water to remove dirt or corrosives, then fully dry unit.
|Main Category||Motors & Accessories|
|Part Type||Hop-up Parts|
|In-Store Pickup QTY||0|
Input Voltage Range: Min. 2S LiPo, Max. 3S, 12.6V
BEC Specifications: Adjustable: 5.5V or 7.5V (2A Peak), default 5.5V
Reversible: Yes, with lockout
On/Off Switch: Waterproof
Dimensions: 1.61x0.75x1.10" (41x19x28mm)
Weight: 1.20oz (34.01g) without connector
Maximum Input Voltage: 3S LiPo
Maximum Operating Temperature: 180°F (82°C)
Motor Size: 1.5x0.79" (38x20mm)
Shaft Diameter: 0.08" (2mm)
Weight: 1.8oz (50g)
Mounting Hole: 1/2" 14mm, 5/8"
Connectors: 3.5mm gold female
Used with Latrax Teton
This kit fit really nice and easy in the Teton. The power is a lot more then the stock. It was tested only with 2s Poly batteries. I got it with the Field Link. The Field Link can be used with the free software from Castle to adjust to throttle curve. If that is done correctly it will give the smooth control that will allow the use off all the power without flipping the Teton or braking drive shafts.
Recommended to buy: Yes
I'm new to RC hobby. Will this fit the LaTrax Teton? If so, is it just replacing the motor and ECU at the minimum to get it to run?
Yes this set up will work in the Teton, from what we have seen you will need to modify the motor mounting plate but its easy to do. You will also need to solder on your battery connector but that should be it.