E-Flite V2 30-Amp Pro Switch-Mode Brushless ESC EFLA1030B

This is the E-Flite V2 30-amp pro switch-mode brushless ESC.

Features:

• Up to 30 amps continuous current with proper air flow and 35amps burst current (15 seconds)
• 3.5A continuous current, 5V Switch-Mode BEC Circuit
• Stronger BEC for support of most 3-axis stabilizationsystems
• Drive up to 7 analog or 6 digital standard-size servos withthe BEC
• 3- to 4-cell Li-Po, 9- to 12-cell Ni-MH/Ni-Cd input voltage
• Programmable motor braking
• Safe power-arm mode prevents accidental starts
• Programmable low voltage cutoff with settings for 3-cellLi-Po (9.2V), 4-cell Li-Po (12V) or 74% of battery starting voltage
• Programmable throttle input range (1.1ms–1.9ms or1.2ms–1.8ms)
• Programmable soft start for helis and airplanes
• Auto motor shut down if signal is lost or there is interference
• Programmable timing—5 user-selectable ranges for use with alarge variety of brushless motors
• Pre-wired connectors—E-Flite EC3 connector on battery inputand 3.5mm gold bullet connectors on motor output leads

Specs:

• Continuous Maximum Current : 30A (proper cooling required)
• Input Voltage: 3 6S Li-Po or 9 18 Ni-MH/Ni-Cd
• Input Connector Types:16 AWG leads with E-flite EC3 Connector
• Output ConnectorTypes : 16 AWG leads with 3.5mm Gold Bullet Connectors
• Momentary PeakCurrent : 35A (15 sec)
• Length: 2.0 in. (51mm)
• Width: 1.1 in. (28mm)
• Height: 0.35 in. (8.70mm)
• Weight: 1.1 oz. (31.0 g)
• Wire Gauge: 16AWG

This product was added to our catalog on February 7, 2013