DuraTrax G-27CX Racing Engine Pull Start DTXG0255

DuraTrax

Item # DTXG0255
$199.99 $169.99
(You save $30.00)
Status: In Stock
Engine Size:
.16 & UP - CAR
UPC:
753600302554
DuraTrax G-27CX Racing Engine Pull Start DTXG0255

More information about DuraTrax G-27CX Racing Engine Pull Start DTXG0255

This is the DuraTrax/SuperTigre G-27 pull start racing engine for the DuraTrax Warhead.

Includes: DuraTrax/SuperTigre G-27 Pull Start Racing Engine

Requires:

  • Car fuel blend with 20% nitromethane content
  • Glow Plug
  • Glow starter, plug wrench and track equipment


Note: This engine is intended for use in the DuraTrax Warhead and does not include an instruction manual. Refer to engine installation and maintenance sections in the Warhead manual.

  • ABC cylinder construction-"A"luminum piston,"B"rass cylinder liner that is "C"hrome plated
  • Dual ball bearing-supported crankshaft
  • Dual needle Slide Valve Carburetor
  • Machined aluminum Red cylinder head
  • Rear exhaust
  • Fully Threaded Crankshaft

Displacement: 0.27 cu in (4.4 cc)

Bore: 0.72" (18.2mm)

Stroke: 0.67" (17mm)

Output: 2.5 hp @ 30,000 rpm

Practical RPM Range: 3,000-35,000

Weight: 14.1oz (400g)

Distance Between Mounting Holes Same Side: 0.83" (21mm)

Distance Between Mounting Holes Opposite Side: 1.4" (37mm)

Height from Bottom of Mounting Tabs/Top of Cylinder Head: 3.6" (92mm)

Height from Bottom of Crankcase to Top of Cylinder Head: 4.2" (107mm)

Width at Mounting Tabs: 1.8" (46mm)

Distance from Pull Start to Front Bearing: 3.3" (84.5mm)

Distance from Pull Start to End of Crankshaft: 3.9" (99mm)

Diameter of Exhaust Opening: 0.59" (15mm)

Diameter of Carburetor Opening: 0.56" (14.2mm)

Factory Needle Settings

High Speed Needle: 4.5 turns OUT from closed

Low Speed Needle: 12.5 turns OUT from closed (1 turn OUT from flush with ball link body)