HPI Nitro Star G3.0 Engine Pull Start HPI15105

HPI Racing

Item # HPI15105
$149.99 $109.99
(You save $40.00)
Status: Out of stock
Engine Size:
.16 & UP - CAR
Fits Model:
HPI Nitro RS4 MT2
Fits Model:
HPI Nitro Firestorm 10T
Fits Model:
HPI Firestorm 10T 2.4
Fits Model:
HPI Nitro RS4 3
UPC:
4944258151052
HPI Nitro Star G3.0 Engine Pull Start HPI15105

More information about HPI Nitro Star G3.0 Engine Pull Start HPI15105

HPI Racing Nitro Star engine has composite body rotary valve carburetor with 5.5mm bore with silver colored cooling head. SG (pilot) type crankshaft. Two year limited warranty.

High Speed Needle Setting: Turn clockwise in 1/8 turn increments to lean fuel mixture. Do not exceed 2-1/2 turns from flush
Idle Adjustment: Adjust for about 0.04 (1mm) gap between slide valve and carb body at bore opening
Low Speed Needle: No adjustment recommended
Displacement: .18 cu in (3.0cc)
Distance Between Mounting Holes Same Side: 0.43 (11mm)
Distance Between Mounting Holes Opposite Side: 1.22 (31mm)
Height/Bottom Mounting Flanges to Top of Cylinder Head: 2.99 (76mm)
Height/Bottom of Crankcase to Top of Cylinder Head: 3.5 (89mm)
Length from Pull Starter to End of Crankshaft: 4.13 (105mm)
Length from Pull Starter to Front Bearing: 3.3 (75.3mm)
Length from Center of Crankcase to End of Crankshaft: 2.96 (75mm)
Diameter of Carburetor Bore: 0.21 (5.5mm)


Requires:

Fuel: Car blend with 20-25% nitro content
Misc Items: Fuel tubing and track equipment

High Speed Needle Setting: Turn clockwise in 1/8 turn increments to lean fuel mixture. Do not exceed 2-1/2 turns from flush
Idle Adjustment: Adjust for about 0.04" (1mm) gap between slide valve and carb body at bore opening
Low Speed Needle: No adjustment recommended
Displacement: .18 cu in (3.0cc)
Distance Between Mounting Holes Same Side: 0.43" (11mm)
Distance Between Mounting Holes Opposite Side: 1.22" (31mm)
Height/Bottom Mounting Flanges to Top of Cylinder Head: 2.99" (76mm)
Height/Bottom of Crankcase to Top of Cylinder Head: 3.5" (89mm)
Length from Pull Starter to End of Crankshaft: 4.13" (105mm)
Length from Pull Starter to Front Bearing: 3.3" (75.3mm)
Length from Center of Crankcase to End of Crankshaft: 2.96" (75mm)
Diameter of Carburetor Bore: 0.21" (5.5mm)