This is a Hot-Shot #2 long Glo-starter with battery charger. This is used to heat glow plugs while starting glow-powered engines. It's the next step up in starting science: a combo that brings together the proven power of Sanyo, the #1 name in NiCds, with the Twist-and-Lock connector, the easiest and most efficient glow plug holder ever known.
Push it in place and with a twist of the wrist, it's locked in place with a grip that vibration can't break, delivering sure starting power that can't be denied. But twist it back, and it slips free for storage and the next time around.
Includes: Hot Shot #2 Long Glo-Starter with Red rubber protective cap, Hot Shot #2 Glo-Starter battery charger and instruction/header card
Sanyo Sub-C NiCd Battery: 1500mAh, 1.2V
AC Charger: Input- 110-120V AC 60Hz (US Standard), Output- 1.25V DC 150mA
Overall Length: 5-7/8 (149mm)
Shaft Length: 3-3/4 (95mm)
Diameter: 15/16 (24mm)
Note: How to use: To lock onto your engine's glow plug, place the end of the Hot Shot 2 over the plug and push down. Twist the Hot Shot 2 clockwise and it locks into place.
Charging: Before using, initial charge should be 12 to 14 hours. Subsequent charging time is approximately 10 hours.