MIP Traxxas Bandit X-Duty CVD Kit MIP18390

This is an MIP Rear X-Duty CVD Drive Kit for the Traxxas Bandit.

Features:

• Strong splined X-Duty steel construction
• Strong 12mm Keyed Hex Standard (Must use 12mm wheels not compatible with pin)
• Fully rebuildable so any damaged or worn part can be replaced. (scroll down on main part # and all rebuild components are there)
• Ultimate upgrade for those that are drag racing!
• No more ripped and twisted drivetrain.
• Heat Treated steel components to help increase strength and part life
• Black Oxide coated to protect the components from premature rust
• 100% Designed / Manufactured / Packaged in the USA

Includes:
1x MIP Inst. Sheet, 18390 Traxxas Bandit
1x MIP Thread Gel Safety Sheet
1x MIP Support Parts Insert Sheet
1x MIP Lube & Thread Gel Cup
2x MIP Confetti Sticker
2x CVD Axles/Traxxas Slash Duty Rear
2x MIP X-Duty Female Bone, 40mm
2x MIP X-Duty, Drive Hub, 13mm w/ 5mm Bore
2x MIP X-Duty Male Bone, 42mm
2x shss/ M3 x 4mm Flat Point
2x Hex Adapter Traxxas X-Duty CVD Kit
4x MIP M4 Pin Screw Slash Diff
4x MIP Bearing Spacer, Rear, Traxxas Slash/ Slash 4x4
2x spacer/ HPI Blitz ft. bearing spacer
5x MIP 1/4" CVD Coupling
5x Ø.092 x .625 Cross Pin w/ flat
5x shss/ 8-32 x 1/8 flat point
2x nut/ m4x.7 steel nyloc

Notes:
When hubs are in the lowest position, clearance on the arm may be necessary for the X-Duty Bell to rotate freely. Best to use a sanding drum to clearance the plastic arm. (check out photo with wrench pointing to area)
Use MIP Grease and Loctite upon assembly.
Be sure to keep joints lubed to enjoy long part life
Front Traxxas 12mm Hex Conversion : 1 x TRA1654
Upgrade Hubs and Bearings recommended : TRA3752 , TRA5116