Traxxas Velineon VXL - 3m Brushless Power System for 1/16 Scale TRA3370

Traxxas

Item # TRA3370
$200.00 $117.99
(You save $82.01)
Status: In Stock
Fits Model:
Traxxas Grave Digger
Fits Model:
Traxxas Summit VXL 1/16
Fits Model:
Traxxas Slash 4X4 1/16
Fits Model:
Traxxas E-Revo 1/16
UPC:
020334337009
Traxxas Velineon VXL - 3m Brushless Power System for 1/16 Scale TRA3370

More information about Traxxas Velineon VXL - 3m Brushless Power System for 1/16 Scale TRA3370

Traxxas Velineon VXL3m Extreme Brushless Power System. This is for the 1/16th scale Traxxas vehicles. Ultra high temp sintered neodymium motor magnets. Balanced rotor. High speed ball bearings. Low voltage detection. Traxxas high current connectors. 16-gauge wire.

Features

  • Traxxas High-Current Connector maintains pure, unrestricted power flow from the battery to the brushless power system.
  • Built-in two-stage low voltage detection for Lithium Polymer (LiPo) battery use provides a clear signal to the driver that the battery pack is nearing its minimum voltage threshold
  • Wide range of battery options, including 6-12 cell NiMH or NiCad packs
  • The patent-pending Training Mode™ is an exclusive Traxxas feature that reduces the overall power output of the VXL-3m by 50%, making it easier for new or younger drivers to control their model. When they're ready, simply change profiles to unleash full-throttle action.
  • Advanced circuit design allows sensorless brushless motors to operate with the smoothness and precision of the best brushed systems. There's no need for additional sensor wiring and hardware complexity.
  • The VXL-3m is programmable with three drive profiles: Sport mode, Race mode, and Training mode
  • Water resistent case design uses rubber seals and o-rings to protect against damage caused by water and moisture.
  • Micro-fin aluminum heatsink dissipates heat.
  • MOSFET design provides high-current output (326 amp peak) with incredibly low resistance (.0005 (Ohm)).
  • Gold plated 3.5mm bullet connectors on 16-gauge Maxx® Cable flow full power to the motor without performance-strangling resistance.


The Velineon VXL-3m forward/reverse electronic speed control simplifies brushless technology with easy, built-in profiles and intuitive programming. The VXL-3m uses advanced circuit design that allows sensorless brushless motors to operate with the smoothness and precision of the best brushed systems. It sets up, operates, and programs just like the Traxxas XL-5 family of ESCs so there's no tricky new procedures to learn. Traxxas' exclusive patent-pending Training Mode is also included to limit full throttle to 50% for young or inexperienced drivers. For the most advanced users, the VXL-3m is equipped with two-stage low voltage detection to allow LiPo battery use, including powerful 11.1-volt 3S packs!

VXL-3M
Input Voltage:
6 to 12 cells NiMH, 2S to 3S LiPo
Case Size:
26.5mm W x 46.5mm D x 22mm H
Weight:
38 grams
Motors:
Sensorless Brushless
Motor Limit:
None
On Resistance:
0.0005 Ohms
PWM Frequency:
12,000Hz
Peak Current:
326A
Continuous Current:
52A
BEC Voltage:
6.0V DC
Motor / Battery Wiring:
16-Gauge Maxx? Cable
Transistor Type:
MOSFET
Low Voltage Detection:
2-Stage indicators, switchable (on or off)
Thermal Protection:
2-Stage thermal shutdown
Single-button setup:
Yes, Traxxas EZ-Set?
Battery Input Connector:
Traxxas High-Current Connector
Motor Connector:
TRX 3.5mm Bullet Connectors

Velineon 380

Type:
Sensorless Brushless
kV (RPM/Volt):
4000kV (8T)
Magnet Type:
High Temp Sintered Neodymium
Connection Type:
TRX 3.5mm Bullet
Wire Size:
16g Maxx Cable
Continuous Current:
25A
Max Current:
50A Burst
Max RPM:
50,000
Weight:
140g (4.94oz)