E-Flite V2 30-Amp Pro Switch-Mode Brushless ESC EFLA1030B

E Flite

Item # EFLA1030B
$59.99 $44.99
(You save $15.00)
Status: Out of stock
E-Flite V2 30-Amp Pro Switch-Mode Brushless ESC EFLA1030B

More information about E-Flite V2 30-Amp Pro Switch-Mode Brushless ESC EFLA1030B

This is the E-Flite V2 30-amp pro switch-mode brushless ESC.


  • Up to 30 amps continuous current with proper air flow and 35amps burst current (15 seconds)
  • 3.5A continuous current, 5V Switch-Mode BEC Circuit
  • Stronger BEC for support of most 3-axis stabilizationsystems
  • Drive up to 7 analog or 6 digital standard-size servos withthe BEC
  • 3- to 4-cell Li-Po, 9- to 12-cell Ni-MH/Ni-Cd input voltage
  • Programmable motor braking
  • Safe power-arm mode prevents accidental starts
  • Programmable low voltage cutoff with settings for 3-cellLi-Po (9.2V), 4-cell Li-Po (12V) or 74% of battery starting voltage
  • Programmable throttle input range (1.1ms–1.9ms or1.2ms–1.8ms)
  • Programmable soft start for helis and airplanes
  • Auto motor shut down if signal is lost or there is interference
  • Programmable timing—5 user-selectable ranges for use with alarge variety of brushless motors
  • Pre-wired connectors—E-Flite EC3™ connector on battery inputand 3.5mm gold bullet connectors on motor output leads

Continuous Maximum Current : 30A (proper cooling required)

Input Voltage:3?6S Li-Po or 9?18 Ni-MH/Ni-Cd

Input Connector Types:16 AWG leads with E-flite EC3 Connector

Output ConnectorTypes : 16 AWG leads with 3.5mm Gold Bullet Connectors

Momentary PeakCurrent : 35A (15 sec)

Length: 51.0mm(2.00 in)

Width: 28.0mm(1.10 in)

Height: 8.70mm(0.35 in)

Weight: 31.0 g(1.10 oz)

Wire Gauge: 16AWG