Great Planes C-7 Nano Brushed ESC w/BEC GPMM2005

Great Planes

Item # GPMM2005
$34.99 $21.99
(You save $13.00)
Status: Out of stock
Fits Model:
Great Planes Yard Stik
UPC:
735557420055
Great Planes C-7 Nano Brushed ESC w/BEC GPMM2005

More information about Great Planes C-7 Nano Brushed ESC w/BEC GPMM2005

This is the C-7 Nano high frequency electronic speed control with BEC. For very small indoor, Park and Backyard flyers with 280-size or smaller Brushed motors requiring 7A or less.

Includes:

  • One C-7 Nano Electronic Speed Control with polarized micro connector for battery
  • 2mm gold plated female bullet motor connectors
  • Universal receiver connector
  • Separate pre-assembled leads with male and female 2-pin connectors
  • One instruction sheet


Requires:

  • Attaching to motor and setting up speed control
  • Battery pack
  • Plug Universal plug into the throttle channel on the receiver


Note: Will handle 3 micro servos with proper cooling. Do not use with brushless motors.

  • Extremely compact size to minimize weight and simplify installation
  • Set battery type with included jumpers
  • Uses "Safe-Start" system to prevent accidental motor starts by disabling the motor circuitry until the throttle stick is moved to full throttle, then to the OFF position
  • Factory installed motor, radio and battery connectors
  • Fully proportional forward only (no brake)
  • Battery Eliminator Circuitry provides sufficient voltage for the receiver and two to three micro servos. The motor battery powers the receiver and servos, then when voltage is reduced to the appropriate voltage, the Low Voltage cut-off circuitry stops the motor while continuing to supply power to the receiver and servos
  • High frequency to optimize battery run-time and cool operation
  • Bright Blue LED and audible tones for easy set-up
  • Very smooth throttle response

Length: 0.66" (17mm)

Height: 0.28" (7mm)

Width: 0.43" (11mm)

Weight: 0.20oz (5.5g) with wires

Input: 6-8 NiCd/NiMH cells; 2-3 LiPo cells

Max Rated Current: 7A continuous

BEC Voltage: 5V/1A

Low Voltage Cutoff: 0.80V per cell for NiCd/NiMH; 2.75V per cell for LiPo

Connectors: Receiver lead- Universal, Battery lead- 2R micro connector, Motor Connector- 2mm gold plated female bullet connectors

Switching Frequency: 2.5kHz

Motor Size: 280 or less Brushed only