Futaba 4YF 2.4GHz FHSS Sport Tx / R2004GF Rx No Servos FUTK4200

Futaba

Item # FUTK4200
$129.99 $99.99
(You save $30.00)
Status: In Stock
Radio Channel:
4-Channel
UPC:
4513886205859
Futaba 4YF 2.4GHz FHSS Sport Tx / R2004GF Rx No Servos FUTK4200

More information about Futaba 4YF 2.4GHz FHSS Sport Tx / R2004GF Rx No Servos FUTK4200

This is the 2.4GHz FHSS Futaba 4YF 4-channel radio system with the R2004GF receiver. Transmitter and receiver only, servos not included.

Includes:

  • 2.4GHz FHSS Futaba 4YF 4-Channel Transmitter
  • R2004GF Receiver
  • On/Off Switch Harness
  • Neck Strap
  • Instruction Manual


Requires: Four AA Batteries for transmitter, servos depending on application and receiver battery pack depending on application

Note: 2.4GHz FHSS is not compatible with FASST systems, and the R2004GF receiver is compatible only with electronics created specifically for 2.4GHz FHSS systems. Can be used in a trainer configuration as the student only. This does require a special Mini Charge Plug if you are going to use NiCd batteries. You can purchase this from your local Great Planes authorized hobby store.

  • FHSS (Frequency Hopping Spread Spectrum) eliminates frequency pins and signal interference-pushbutton transmitter/receiver linking with no binding plugs
  • R2004GF receiver has coaxial antenna that can be positioned inside model for optimum reception
  • Power Down Mode - reduces RF power for 90 seconds, simplifying ground checks for interference
  • All-channel servo reversing for more installation options
  • Power and servo reversing switches are located down and out of the way for convenience and to avoid accidental changes
  • Battery meter features one Green and one Red LED for easy-to-read GO/NO GO status, does not have battery failsafe function
  • Elevon mixing
  • Gimbals have knurled tops for a better "feel" on the sticks and to prevent finger slippage

Transmitter

Transmitting Frequency: 2.4GHz band

Power Requirement: Four AA cells

Current Drain: 90mA

Trainer Port: Micro

Receiver

Power Requirement: 4.8-6V shared with servo

Current Drain: 30mA at no signal

Size: 1.54x1.02x0.39" (39x26x10mm)

Weight: 0.49oz (14g)